Interfacing sensors
Iot : Interfacing sensors Program List
Program [1]
Arduino program to change the blinking speed of led using the potentiometer
Program [2]
arduino program to interface buzzer with Arduino board to buzz on off with the delay of 1sec
Program [3]
Arduino program to Blink a Light Emitting Diode LED
Program [4]
Arduino program to print Hello word in LCD
Program [5]
Arduino program to interface the sensor and led
Program [6]
Arduino program to sound the buzzer on press on push button for 1 second
Program [7]
Arduino program to interface buzzer with LDR and LED
Program [8]
Arduino program to create automatic street light control by using LDR sensor
Program [9]
Design a night lamp using a LDR and a LED using Arduino Uno and find out the time delays associated in keeping ON the lamp
Program [10]
Write a program to interface a temperature sensor (LM35) and water Nozzle with the Arduino.
Program [11]
Arduino program to interface led buzzer with Arduino or raspberry pi and turn ON LED for 2 second after every 3 second
Program [12]
Arduino program representing smart street light concept
Program [13]
Arduino program to interface DC Motor with potentiometer
Program [14]
Arduino program to interface a servo motor and a button at pin 7
Program [15]
Write a program to interface a gas sensor (MQ-2) and a buzzer.
Program [16]
Write a program to interface a PIR motion sensor and an LED with the Arduino. The LED should turn on for 5 seconds whenever motion is detected.
Program [17]
Arduino program to read data from sensor and send it to a requesting client.
Program [18]
Arduino program using any one development board (E.g., Arduino or Raspberry Pi) to read data from a sensor
Program [19]
Write a program for detection of the light using photo resistor with output as light detected and LED state.