Writing code in sketch
Iot : Writing code in sketch Program List
Program [1]
Arduino program to connect a led through push button
Program [2]
Arduino program to connect RGB Led Bulb
Program [3]
Arduino program to turns on LED when the button is pressed once and remains on until the button is pressed again to turn it off
Program [4]
Arduino program to interface security password with Arduino board to show green light for correct password and red light for incorrect password.
Program [5]
Arduino program to input any integer number and print its table
Program [6]
Arduino program to connect with Servo Motor
Program [7]
Arduino program to interface LCD with Arduino board and print some text
Program [8]
Arduino application where pressing a button increases a counter value, which is then displayed on an LCD
Program [9]
Arduino program to interface DHT 22 sensor and find the Humidity Temperature and Heat index
Program [10]
Arduino program to interface soil moisture sensor
Program [11]
Arduino program to interface a temperature monitoring system in a public environment which will display information
Program [12]
Arduino program to interface a PIR (Passive Infrared) sensor
Program [13]
Arduino program to interface gas sensor to detect the gas
Program [14]
Arduino program to Design a night lamp using a photodiode and a LED and find out the time delay associated with turning the lamp on and off.
Program [15]
Arduino program to implement Two way traffic signal system.
Program [16]
Arduino program to interface LEDs at pins 10,11,12,13 and button at pins 7. The press of button changes the pattern of LED glow. (considering four patterns of LED glow)
Program [17]
Arduino program to Increment and Decrement led light using 2 push button
Program [18]
Write a program to interface a button and an RGB LED with the Arduino. On each button press, the RGB LED should change its color in the sequence: Red, Green, Blue.
Program [19]
Write a program to print “Hello World!” to the LCD (Liquid Crystal Display) and shows the time in seconds since the Arduino was reset.
Program [20]
Write a program to interface four LEDs (pins 10, 11, 12, 13) and a push button (pin 2) to toggle the LED states as follows:
Program [21]
Write a program using any one development board (Eg., Arduino or Raspberry Pi) to read data from a sensor. Experiment with both analog and digital sensors.