Internet of Things and its Applications Programming Examples

Interfacing sensors

Program - 1

Arduino program to change the blinking speed of led using the potentiometer

Program - 2

Arduino program to interface buzzer with arduino board to buzz on off with the delay of 1sec

Program - 3

Arduino program to blink a light emitting diode led

Program - 4

Arduino program to sound the buzzer on press on push button for 1 second

Program - 5

Arduino program to print hello word in lcd

Program - 6

Arduino program to interface the sensor and led

Program - 7

Arduino program to interface buzzer with ldr and led

Program - 8

Arduino program to create automatic street light control by using ldr sensor

Program - 9

Design a night lamp using a ldr and a led using arduino uno and find out the time delays associated in keeping on the lamp

Program - 10

Write a program to interface a temperature sensor (lm35) and water nozzle with the arduino.

Program - 11

Arduino program to interface led buzzer with arduino or raspberry pi and turn on led for 2 second after every 3 second

Program - 12

Arduino program representing smart street light concept

Program - 13

Arduino program to interface dc motor with potentiometer

Program - 14

Arduino program to interface a servo motor and a button at pin 7

Program - 15

Write a program to interface a gas sensor (mq-2) and a buzzer.

Program - 16

Write a program to interface a pir motion sensor and an led with the arduino. the led should turn on for 5 seconds whenever motion is detected.

Program - 17

Arduino program to read data from sensor and send it to a requesting client.

Program - 18

Arduino program using any one development board (e.g., arduino or raspberry pi) to read data from a sensor

Program - 19

Write a program for detection of the light using photo resistor with output as light detected and led state.